UV Skin-Feel Resin: B-241


I. Basic Parameters

II. Performance Testing

2.1 Recommended Formulation for Skin-Feel Coatings
2.2、Skin-feel layer process flow and skin-feel texture testing results
The skin-feel resin to be tested is added separately into the skin-feel coating formulation, mixed thoroughly, and then coated onto a white PC board (25 μm thickness) for testing. The following curing methods are employed:
① First, cure once using a 395nm LED lamp with a curing energy of 100–200 mJ.
② Using a 254nm wrinkle lamp, both B-241 and the commercially available skin-feel resin A, after being run through the machine once, became essentially matte; after being run through twice, they were essentially surface-dry.
③ Finally, cure with a UV mercury lamp at an energy level of 300 mJ until fully dry; the surface feels smooth and pleasant to the touch.
Summary: B-241 and the commercially available skin-feel resin A deliver excellent matting effects and good skin-feel when used with a 254nm wrinkle lamp.
2.3 UV Yellowing Comparison
2.2 Apply a cured coating, then subject it to 10 passes through a mercury lamp under forced conditions, with each pass delivering an energy of 300 mJ, and compare the yellowing behavior.
The above are comparison images after the UV treatment has been applied 10 times. The yellowing data is as follows:
As shown in the images and data, the initial and forced UV yellowing of Boxing B-241 is comparable to that of commercially available skin-feel resin A.
2.4 QUV Yellowing Comparison
Skin-feel curing coating, aged for 7 days in a QUV chamber; compare the yellowing conditions. (QUV equipment conditions: 45 W.)
It is clearly visible to the naked eye that after 7 days of QUV exposure, the yellowing of the coating on B-241 is significantly less than that of the skin-feel resin A.
The above are comparison images after 7 days of QUV aging. The yellowing data are as follows:
As shown by the images and data, the B-241 from Boxing exhibits significantly superior yellowing resistance under QUV exposure compared to the skin-feel coating made from commercially available skin-feel resin A.
III. Summary
Boxing Skin-Feel Resin B-241 is a difunctional polyurethane acrylate that can be used as the main resin in excimer skin-feel coatings. It cures via 395nm LED—254nm or 172nm excimer lamps combined with mercury lamps. This resin features rapid matting, excellent skin-feel performance, and superior resistance to yellowing under QUV exposure.

Recommended for use in architectural coatings or plastic coatings with a skin-feel finish applied to lighting fixtures.

 

Share to:

Related News